Y Bed wire management (Prusa i3 and clones)

Description

Wire Management For Prusa I3 And Clones To Prevent Bed Heater Wires From Getting Overly Stressed And Breaking Or Shorting Out. Version For Left And Right Of Center Depending You Your Printer And Were/How The Motor And Such Are Mounting. Mount To The Lower Carriage Plate Of The Bed . There Is No Mounting Screw Hole As There Is Just Too Many Different Beds Out There. Print Up And Either Drill Out Or Just Hold The Screw Over A Candle And Heat Up And Poke Through The Plastic. Recommend Printing With High Shell/Outer Layer But Inners Can Be Low (Wouldn'T Go Under 20% Though Personally)

Statistics

Category

Tags