14ZTop with bearing holder
Description
I Wanted To Add A Bearing At The Top So I Can Eventually Link The 2 Z Axis Via 1 Belt And Use 1 Motor. Once The Belt Arrives I Will Design A Motor Mount At The Top To Suite. I Remixed The Original And Found The 10Mm Bar Support Wasn'T In The Center Which Caused A Slight Misalignment Of The Shaft And Threaded Rod. This Is Now Fixed. I Had To Shorten The Top Openbeam Bar By 70Mm As The Bearing Support Is Now In There. This Part Is Now Symmetrical So You Can Print 2 The Same Or Use The Slicing Software To Mirror The Part.
Statistics
Likes
7
Downloads
0