Customizable Camera Mount for FlexRC Mini Owl Quadcopter

Description

This Is A Customizable Camera Mount Intended For Use On The Flexrc Mini Owl Quadcopter. While Intended For The Mini Owl, It Could Probably Also Be Used For The Full-Sized Owl Quadcopters, With Appropriate Customization Via The Customizer. (I Do Not Have A Full-Size Owl To Try It On, But If Anyone Wants To Send Me One To Test, I'M Happy To Do So! ;-) It Might Also Be Adaptable To Other Double-Plate Quads Like The Lumenier, Etc. The Height, Width, Depth, Thickness, Hole Sizes For Camera Lens And Mounting Posts, Camera Position Fore/Aft, And Camera Angle Can All Be Customized. (For Instance, My Camera Has A Built-In Vtx, So Needs To Be Positioned A Little Bit Forward, So That The Props Clear The Camera Body. I Also Like A Little Bit Of Upward Angle On My Camera - As Shown In The Photo From The Side.) Note That Camera Angles Will Affect How Thick The Mount Wall Needs To Be - A Steeper Angle Will Require A Thinner Wall, While A Flatter Angle Will Allow A Thicker Wall - Some Measurement And Experimentation May Be Required To Find The Best Fit. The Mount Will Print In An Upper Half And Lower Half, For Clamping Around The Camera Lens Neck. It Prints With The Lens Mounting Hole Halves Facing Upward, So No Support Material Is Needed. The 'Print Offset' Parameter Specifies The Y-Axis Distance On The Print Bed Between The Two Printed Halves Of The Mount. (Should Be Fine At Its Default Value, But If You Need To Change It, You Can.) I'M A Big Fan Of Printing Holes A Bit Undersized, And Drilling/Reaming Out With A Drill Bit Post-Print, As The Drill Bit Tends To Provide A Much More Precise Hole Size.

Statistics

Category

Tags