24 Volts LED interior lighting
Description
Let There Be Light... The Following Instructions Are Only Useful For Electrically Talented People. No Liability Is Assumed For Damages Resulting From This! The Led Modules Can Be Connected Directly To The 24 Volt Power Supply. By Connecting The Seven Leds (See Circuit Diagram), The Operating Voltage Is Divided (24Volt / 7 = 3.4Volt) And Supplies The Individual Led With The Required Voltage. Each Module Has The Same Structure And Can Be Switched As Often As Required (4 Modules In My Case). For The Purchase Of The Required Material I Prepared A Shopping Basket At An Electronics Dealer: Https://Www.Reichelt.De/?Action=20&Awkid=1284736&Language=En Two 16Cm Long Copper Wires Are Used For One Module, As Shown In The Figures. It Is Started With The Inner Two Holes. The Wire Is Folded 1.5 Cm Outwards. Then The Leds Are Pressed In (The Longer Leg Is The Anode). The Diodes Are Each Connected From The Cathode To The Anode. Led1 Is Soldered From The Anode To The Plus Bus And Led7 Is Soldered From The Cathode To The Minus Bus. Remove On The Contact Surfaces The Varnish From The Wire - A Sharp Knife Is Helpful. The Connections For The Positive Pole (+) I Marked With A Red Edding. A Function Check Can Now Be Performed. After Successful Lighting, The Isolation Tape Can Be Fixed. In The Case Of The Wrapped Diodes, The Led Is Exposed By A Cross-Cut On The Top. When Connecting The Terminal Block, A Wire Is Bent So That The Module Is Tilted 45 Degrees. The Following Installation In The Printer Must Be Carried Out With Attention, As There Is Little Space Available! In The Case Of Correct Wiring As Well As Connecting From One Module To Another, All 28 Leds Should Light Up. The Total Current Consumption Is About 220Ma (5,3Watt). A Suitable Fuse Is Strongly Recommended.
Statistics
Likes
122
Downloads
0