Y Axis Prusa Endstop
Description
This Is A Revision Of The Y Endstop By Pavolnovak. This Endstop Is To Be Used With More Commonly Found Limit Switches (See Link Below). It Snaps On The Rear Rails Of Your Prusa I3 And Is Very Secure. The Switch Will Interact With The Bed Carriage And Should Line Up Perfectly. There Are Mounting Holes For The Switch Itself To Bolt Through. Revised On 8-29-17, This Revision Moves The Switch Rearward To Allow Full Y Axis Travel. Switches That Should Be Compatible: Http://Www.Digikey.Com/Short/3593B0
Statistics
Likes
4
Downloads
0