Raspberry pi 2.8in screen Stand
Description
I Had A Raspberry Pi With A Screen To Run Octoprint But I Found That The Sandwich Thing Wasn'T Working For Me And Other Stands Were Either Not Designed For The Smaller Screen Or Just.... Not What I Wanted. I Also Wanted To Separate The Screen And The Board Because Cooling And I Wanted To Use The Remainder Of My Io Ports. I Quickly Designed This Little Number To Hold Your Pi, A Screen, A Little Platform For Mini Breadboard If You'Re Lazy Like Me And Don'T Want To Solder. There'S Also A 40Mm Fan For Keeping Your Pi And Your Screen Cool. It Uses As Lot Of Those Little Single Pin Extender Thingies To Connect The Screen Away From The Gpio (With A Pass Through If They'Re Too Long Since Cutting Isn'T Lazy. Later Versions I'M Going To Try And Split It So It Doesn'T Need Supports. Right Now There'S A Lot Of Support Work Since I Was Again Being Lazy But Also I Have A Spool Of Water Logged Pla That I Wanted To Use Up (Hence The Questionable Quality Of The Print In The Picture.).
Statistics
Likes
1
Downloads
0