Anycubic Kossel PCB cooling 40x40 fan + stepper driver Aero Tunnel
Description
If You Have Installed A Heated Bed On Your Printer And You Think That The Control Board Needs Cooling, Use This Thing. "It Works Perfectly For Cooling Your New Tmc2100" Update: - Now Is Available To Install The "Aero Tunnel" For Cooling Your Stepper Driver Without Interfering With The Heating Of Your Heated Bed. - The Update Consists Of An Add-On, It Does Not Involve Any Change To The Previously Installed Pcb Support. ************************************************************************************** I Used This Fan Configuration For My Controller Board: Extruder Cooler: Fan1 Connector Pcb Cooler: Fan2 Connector Setting Up Two Simple Changes This Firmware Https://Drive.Google.Com/Open?Id=0B8Vib533Cgdmdvl2Z2Thwkjhbta In "Configuration_Adv.H" 1: #Define E0_Auto_Fan_Pin -1 -----> Edit To #Define Value E0_Auto_Fan_Pin 7 2: #Define Controllerfan_Pin -1 -----> Edit To #Define Controllerfan_Pin 44 For Peace Of Our Ears, The Pcb Cooling Fan Will Be Started Only When Printing, But Will Be Turned Off To Finish Printing. ;-) You Can Reverse The Pin 7 To Pin 44 At Your Convenience, It Depends Of The Connector You Used For Your Fans ************************************************************************************** Update V1.2: - Tunnel With Increased Height And Length For Tmc2100 + Protector Filter Or With Big Heat Sink For Higher Cooling Performance
Statistics
Likes
342
Downloads
0