Make out with Mistletoe
Description
Happy Holidays - Hope You Get Lucky Under The Mistletoe! There Are Two Versions Of Leaves As The First One I Made Used A Holly Leaf But That Is Not Botanically Correct. More Information: [Kissing Under The Mistletoe Or Is It Holly?](Http://Www.Botanicalaccuracy.Com/2014/12/Kissing-Under-Mistletoe-Or-Is-It-Holly.Html) I Designed This On Tinkercad And Printed In Ninjaflex. Not Sure How It Will Work Out In Other Filaments (Mainly The Connector). I Added The Connector To Keep The Leaves And Berries Spaced Properly When Hanging. The Leaves Go In The Outside Holes And The 3 Berries Go Through The Same Center Hole. If You Use A Harder Filament You Could Probably Push Into A Small Piece Of Styrofoam For The Spacers Instead Of Using The Connector. I Printed Another One In Semiflex - Not Much Difference Except It Fits Better In The Connector.
Statistics
Likes
26
Downloads
0