EndStop Striker for Optical EndStop
Description
A Simple "End" For A Bolt That Can Be Used To Actuate The Typical Optoisolator Found On An Optical End Stop. Need To Make The Nut Hole Big Enough To Fit A Nylock (9.4Mm Worked For A #6 But Barely On My Printer). Use The Customizer! Force Fit The Nylock Into The Hole (Ca Glue If Desired) And Tighten The Striker Bolt In. The Only Problem I See Is That For A 6-32 Bolt, You Must Go In 1/2 Turn Increments (So The Striker Fits In The Slot) And That'S About 400 Microns Of "Step" -- Not Bad Probably Except Maybe For The Dimension Over The Bed. Haven'T Tried It Out Yet.
Statistics
Likes
8
Downloads
0