Logitech C270 mount for Hephestos 2
Description
This Thing Allows To Mount A Logitech C270 Usb Camera To Your Hephestos 2'S Y-Carriage, To Have It Move With The Bed During Printing And Allow A View Of The Ongoing Print Undisturbed By Motion. Naturally I Use This With [Octoprint](Http://Octoprint.Org) ;) This Thing Mounts Into Two Existing M4 Holes On The Front Of The Hephestos 2'S Y-Carriage. The Position Of Camera Is Designed Such That The Lens Is Located On The Center Line Of The Bed. The Camera'S Front Is Located Just Outside The Movement Area Of The Print Head And Thus Should Not Cause Any Problems. **Note:** I So Far Have Not Discovered Any Artifacts In My Prints Caused By The Added Weight In 4 Months Of Printing With This Setup, But Ymmv. Also, For High Prints The Model Might Run Out Of The Visible Angle - I'M Still Looking Into Somehow Mounting A Wide Angle Attachment To The Camera'S Lens Or Maybe Mount It Vertically To Compensate For That. If You Are Concerned About Any Of These Downsides, This Might Not Be The Best Solution For You. In Order To Build This You'Ll Need To Print: * 1 X Cameramount_Bracket_Left.Stl * 1 X Cameramount_Bracket_Right.Stl (With Support From Platform) * 1 X Cameramount_Arm_C270.Stl (With Support For The Two Hinge Components) Or Just: * 1 X Cameramount_Plate.Stl (With Support As Above, Should Fit On Your Hephestos 2'S Bed) Additionally You'Ll Need: * 2 X M4X10Mm Screws (E.G. Din 912) * 2 X M3X16Mm Screws (E.G. Din 912) * 1 X M3X30Mm Screw (E.G. Din 912) * 3 X M3 Hex Nut (E.G. Din 934) If You Need To Make Any Adjustments (E.G. To Support Another Camera Model), You Can Find The Fusion360 Files [Here](Http://A360.Co/2Gkvxkx).
Statistics
Likes
50
Downloads
0