Two Piece Steampunk Cyborg Monacle Headpiece
Description
I Had Problems Printing The Original, Due To Problems With Print Bed Levelling On My Printer, So I Made A Two Part Version Without The Ear Support. Should Print Nicely On A Properly Functioning Printer. Unfortunately Again My Printer Had A Problem Printing And The Nose Support Detached Itself From The Bed. It Also Had A Catastrophic X-Y Jump About 5Mm From The Top, Forcing Me To Stop The Print. I Fixed This By Reprinting Just The Top Few Layers And Glueing Them On. Not As Pretty As I Wanted But I'M Not Willing To Waste Another 3,5 Hours! It Might Be A Good Idea Redo The Supports And Connect The Nose Support To The Rest Of The Model On The First Layer If Your Not Sure Your Printer Can Handle This. Timelapse Of The Print: Https://Www.Youtube.Com/Watch?V=-Uldzd5Wyps
Statistics
Likes
29
Downloads
0