WiFi Eye of Agomotto
Description
This Is One Of The "Case" Variants For The Wifi Eye Project, Published By All About Circuits Here: Https://Www.Allaboutcircuits.Com/Projects/Wifi-Eye-Part-1-Intro-Diagram-Bom-Features-Iot/ Print The "Core", "Middle Plate" And A Pair Of "Eye Lids" First If You Are Building The Electronics, So You Can Be Busy While The Big Amulet Body Prints. The "Amulet" And "Crossbeams" Are The Only Pieces That Definitely Need Support - The Crossbeams Are Quite Thin And You May Need To Experiment To Get Them Right. Once Cleaned Up, Glue It A Few "Spokes" At A Time To The Amulet Face With Epoxy Or Ca. The Amulet Needs Supports For The Pockets Underneath That Hold Electronics Components. These Will Be Rough, But Hidden. The Crossbeams Look Much, Much Better When They "Float" Over The Amulet Face (And Let Light Through The Gaps) Rather Than Being Solidly Connected To It. And Removing Supports From A Separate Piece Is Far Easier Than Getting Them Out Of The Middle. The "Woggles" Slip Over The Ends Of The Necklace Cord (I Used Shoelaces) To Make It Look Nicer Where They Tie To The Amulet. The Curved Part Is Meant To Fit Over The Amulet Lops. The Stand Has A Build Support Pre-Baked-In, Which You Should Cut Away Carefully Afterwards With Diagonal Cutters... A Slightly Ratty And Uneven Edge Works Well For "Feathers", Just Be Careful Not To Split The Piece Along Layer Lines. Also See The "Destiny Ghost" For An Alternate Build: Https://Www.Thingiverse.Com/Thing:2202429
Statistics
Likes
178
Downloads
0