Prusa i3/Hesine M505 (Anet A8 compatible) x Carriage for E3Dv6 (Bowden)

Description

### X Carriage For E3Dv6 I Needed A New X Carriage For My Printer. I Switched To The P3Steel, From The Original Anet A8 Acrylic Frame, And Lost A Bit Of Z Print Area. There Are A Lot Of Great Carriages Already Existing, But I Decided To Have A Go At Designing My Own, From Scratch. Included Are The Full Build (With Fan Mount + Sensor), A Simpler Version With Only The Sensor Mount, As Well As Just The E3Dv6 Mount. For The Moment, I'Ve Only Designed A 18Mm Sensor Mount. I Will Eventually Release A Version For A 12Mm Sensor, I Just Haven'T Been Able To Get Around To It Yet. ##### Disclaimer :P I Am By No Means A 3D Design Expert. This Is Very Much A Side Project, Mainly So I Can Learn, Have Fun, And Build A Part For My Printer =) There Is Definitely Room For Improvement, And I Will Work On It When I Am Able To. Comments/Suggestions From More Experienced Designers Are Most Certainly Welcome! ##### Fan Duct The Current Version Of The Fan Duct Most Certainly Needs Work. Airflow And Angles Of The Holes Needs To Be Redone. It Works, But Has Trouble Cooling Fine Detail, I Will Try To Get To This In The Next While. ##### Belt Holder The Holes On The Back Are Designed So Any Belt Holder For The Anet A8 Can Be Used (Example: Http://Www.Thingiverse.Com/Thing:1433295) ##### Printing This Print, Is Most Certainly Not An Easy Print. You Will Definitely Need Supports, But Also To Make Sure That No Supports End Up In The Fan Ducts. Something Like Simplify3D Is Recommended, So You Can Chose Where Supports Go. #### Marlin Sensor Offset ``` #Define X_Probe_Offset_From_Extruder -38 #Define Y_Probe_Offset_From_Extruder -3 ``` ***Note***: You Can'T Use Floating Point Numbers In These Constants, So I'Ve Rounded Them. #### Anet A8 Settings ##### Anet A8 ``` Define Right_Probe_Bed_Position -179 Define X_Min_Pos -13 ```

Statistics

Category

Tags