XSeries Remote holder for selfie stick
Description
This Is A Snap On Remote Holder For The Xs Series Selfie Stick I Got From Scheels. I Knew I Would Loose The Remote If It Wasn'T Attached To The Handle Somehow. This Was Printed In Bridge Nylon At 245 Degrees But Would Work In Pla Or Any Other Material Of Your Choice. Depending On Your Printer Calibration You May Need To Soften The Part The Snaps Onto The Stick And Constict It Slightly To Make It Hold Onto The Stick A Little Tighter.
Statistics
Likes
2
Downloads
0