Quadrysteria Rush 4" Rx Antenna Mount
Description
This Is A Mount For Antenna Tubes For The Receiver Antennas In A Quadrysteria Rush 4" Drone. I'M Using This With A Frsky Xsr Receiver, Routing The Antenna Wires Up Through The Hole In The Top Plate And Then Into The 3D Printed Part. Then Appropriately Trimmed Antenna Tubes Are Pushed Into The 3D Printed Part. Use A Couple Patches Of Servo Tape To Help Hold It Down, And Then Add A Zip-Tie Once The Top-Plate Is Back On The Drone. Use Tpu, No Raft, No Supports.
Statistics
Likes
10
Downloads
0