E3d mounted 40mm fan layer cooler
Description
This Is A Modified Version Of Someone Else Design. I Made It So That You Only Use The 2 Screws From The E3D Fan/Cooler And The 40Mm Fan Is Fitted And Does Not Need Screws Note: This Was Done For Abs If You Make It With Pla And It Is Slightly 2 Loose Because Pla Does Not Shrink As Much As Abs Just Put A Piece Of Scotch Tape On The Inside Edge Before Putting The 40Mm Fan In Place Or You Could Scale It From 100% To 99.9% And That Should Do The Same Thing You Will Have To Print This With Supports But They Are Nominal Tips In Any Amount Are Appreciated: Https://Www.Paypal.Me/Satgod
Statistics
Likes
5
Downloads
0