Spool holder for original Prusa i3 MK2
Description
I Really Like My Original Prusa I3 Mk2 A Lot. However, The Spool Holders Are Not My Favorite Solution. So I Just Created My Own. My Part Is Quite A Bit Thicker Than The Original Part And Instead Of Using Integrated Plastic Bolt Stubs, It Just Has Holes That Accept Any 10 Mm Rod. I Use A Steel Rod Myself. The Holding Arm Also Has A 2,7 Mm Hole From The Bottom. You Can Screw In An M3 Screw In Order To Clamp The Spool Holder On The I3 Frame. I Just Use M3 Allen Screws And Tighten Them By Hand. Works Great For Me.
Statistics
Likes
1
Downloads
0