i3 v2.0 OR v2.1 Rear Mount Cooling Fan Frame for 60 mm OR 40 mm fan
Description
This Is A Snap On Or Bolt On Frame For The I3 V2.0 Or I3 V2.1 (Mk10 Hot End) To Mount A 60 Mm Or 40 Mm Fan, That Goes On The Back Of The X Axis Carriage. It Is Modular For Printing Ease And Simple Changing Of The Fan / Duct. Update I Have Added A Rear Duct That Holds A Usb Camera, See Below For More Info. There Are Two Versions Of The V2.0 Frame. One Is A Tight Fit Snap On. The Other Is Simpler To Mount, But Requires Two 3 Mm X 8 Mm Bolts With Nuts Or One Thin Zip Tie About 100 Mm Long. There Is Currently One Version Of The V2.1 Frame. It Requires Two 3 Mm X 18 Mm Bolts With Nuts (Washers Are Suggested) Or One Thin Zip Tie About 120 Mm Long. There Are Two Versions Of The Duct Part, Which Holds The Fan. One Is Sized For A 60Mm Fan And The Other Is For A 40Mm Fan. Any Of The Ducts Will Snap On To Any Of The Frames. The Fan Duct Simply Plugs Into The Square Holes On The Back Of The Frame. You Will Likely Have To Trim The Square Plugs On The Duct And Also The Square Holes On The Frame, As It Is A Tight Fit. When Removing Support From Inside The Duct Be Careful You Don'T Remove The Thin Guide Walls Inside. They Are Very Thin - 0.8 Mm. I Printed At 2.0 Mm Layer With 40 % Infill In Pla. Usb Camera Mount - Http://Www.Thingiverse.Com/Thing:2208781 This Is A 60 Mm Axial Fan Duct That Holds A 6 Mm Usb Camera - Https://Www.Amazon.Com/Gp/Product/B00N4L5N4A/Ref=Oh_Aui_Detailpage_O05_S01?Ie=Utf8&Psc=1 --------------------------------- In Progress - I Am Making A Blower Fan Duct, That Will Be Half As Long, So It Won'T Stick Out The Back As Far. Also, I Am Extending The Nozzle Out Some, To Be Closer To The Hot End.
Statistics
Likes
24
Downloads
0