90mm Cradle Extended (up to 82 mm!)

Description

This Is Another Remix Of The Cradle. Once Again, Use The Pins From The [Source](Https://Www.Thingiverse.Com/Thing:1332650). This Cradle Is For Spool That Are As Small As 61Mm (__Minus The Outer Walls Of The Spool__) And As A Big As 82Mm (__With The Outer Walls Of The Spool__). Although The Thinner Support For The Bearing Is Solid Enough To Hold The 1Kg Spool Comfortably, I Would Suggest To Push The Pin Through The **Stronger Support** First (As Seen As In The Pictures). It Does Bend A Bit When Pressure Is Applied Toward The Other Support. I Suppose I Could Have Made The Outer Support Of The Other Side Thinner As Well But When I Measured It In Meshmixer, The Size (82 Mm) Was Ample Enough For The Spool I Had (Monoprice Orange Abs). If Anyone Want Me To Make The Thinner Outer Support On The Other Side, Please Mention It In The Comment. =) It Was A Bit Harder To Make Than My Other [Smaller Cradle](Https://Www.Thingiverse.Com/Thing:1999938) Since I Had To Make A Couple More Slices Through The Cradle So I Could Keep The Other Proportions. Basically, If You Only Slice The Outer Support For The Side Of 1 Bearing And Reduce The Scale, You End Up With A Space That Is Less Than 1 Bearing Between The Two Supports. I Had To Slice The Middle Part Between The Two Supports To Scale It Up So The Space For The Bearing Would Remain The Same, Despite A Thinner Outer Support. Also, I'Ve Included The Meshmixer File.

Statistics

Category

Tags