Wanhao i3 V2.1 LED Bar Light Strip Mount Mk2
Description
This Is A Led Light Strip Holder That Mounts To The Front Cooling Fan Holes On Your V2.1 Wanhao And Its Clones. The Mk2 Versions Have Been Added!!! This Version Has A Slightly Better Wire Holding System And Much Lower Walls. It Also Shrunk The Screw Holes And Capped The Back Of Them For A Much Better Fit. The Mk2 Includes A Couple Different Style Light Bars My Favorite Being The Ultra High Due To Its Very Small Profile And The Low Due To The Fact That It Actually Lights Up The Very Tip Of Your Nozzle!!! Requirements: - Wanhao I3 Or One Of Its Clones. - Rear Cooling Setup Like My 50Mm Cooler. Http://Www.Thingiverse.Com/Thing:2022857 - Led Light Strip Http://Tinyurl.Com/Hv63D8P - Jst Xhp-2 Connectors To Make A Y Cable For You Extruder Heat Sink Fan Wire. Installation: Install The Led Strip(You Will Have To Cut A Sliver Off Most Likely) Solder A Jst Xhp-2 Connector To Around 3In Of Wire. Make A Jst Xhp-2 Splitter(Y Cable) So You Can Pull Power For The Led'S From Your Heat Sink Cooling Fan. Install The Splitter. Remove Your Stock Cooling Fan. Install The Led Light Bar With The Stock Hardware. Contact Me Directly If You Need Any Help! Please Feel Free To Contact Me With Any Advice, Ideas, Or Complaints. Tips Are Much Appreciated! Future Improvements: Side Mount Version. Eta Feb2017
Statistics
Likes
71
Downloads
0