Bedini SG style motor (mechanical components)

Description

Here Is A Easy And Fast To Print Model Of An Bedini Sg Motor. You Have To Get Some Additional Parts For A Successful Assembly Of This Kit. - 2 X Ball Bearing 15 X 10 X 4 Mm (Typical Outer Wheel Bearing Of Front Axle Of An Axial Rc Model). You Should Get These Bearings At Your Local Rc Store. - 22 X Screw 3 X 12 Mm (Special Thread For Plastic). Also Used On Axial Rc Cars, So You Should Find These Screws Also In Your Local Rc Store. - 24 Neodynum Magnets 8Mm In Diameter, 5Mm In Hight (You Only Need 8 If You Use The 8 Magnet Rotor). - Some Welding Rods For The Iron Core Of The Coil - 250M Of 0.2Mm Magnet Wire And 250M Of 0.3Mm Magnet Wire - The Components To Built The Elctronic Circuit (Can Be Found On Internet) These Parts Have To Print More Than Once: 2 X Rotor_Stand.Stl 2 X Connector.Stl 4 X Rubber_Feet.Stl Assembly Tips: Glue Together The Upper And Lower Part Of The Coil. Complete Your Coil By Adding The Iron Core And The Coil Wires. Screw Your Finished Coil To The Part Mounting_Plate.Stl. Place The Part Center_Rod.Stl In The Midlle Hole Of Part Rotor_Xx_Magnets.Stl Then Screw On The Hubs. Also Add The Magnets (Maybe You Have To Grind The Holes With A Dremel To Fit The Magnets Properly) After That You Have To Press The Ball Bearings Into The Parts Rotor-Stand.Stl. Screw One Rotor_Stand.Stl To The Mounting Plate (Bearing Faces Towards The Rotor). Add The Rotor. Screw On The Parts Connector.St (Connects The 2 Rotor Stands) And The Second Rotor Stand. The Parts Rubber_Feet.Stl Will Be Glued To The Lower Side Of The Mounting Plate. Add Your Bedini Circuit And Start The Motor!! Have Fun With This Kit!!!

Statistics

Category

Tags