CobbleBot Z Axis Alignment
Description
The Cobblebot Has A Very Challenging Z Axis. It Is My Intent To Help With The Alignment. Mounting This Support To The Top Rail Directly Over The Z Motors And Correcting The Alignment On The Zy-Axis .( Basic V2 Center Z Motors And Alignment Mount At 250Mm) This Will Correct The Alignment, And Stop The Binding Causing The Z Axis To Not Move. It Can Be Used With Or Without A 608 Bearing. Down Side,,, Only Tested On Cobblebot Basic V2 1/16/2017: I Have Corrected Some Flaws I Found. Corrections: Center Bore To 8.8Mm. Bearing Race To 22.4Mm Flanges Were Too Short To Print. Cobblebot Z Axis Alignment 0.5 Is The Most Current & Most Likely The Final Revision. Https://Youtu.Be/R8_Fyubojhg.
Statistics
Likes
6
Downloads
0