Playstation 4 VR belt clip
Description
This Is A Belt Clip To Hold The Playstation 4 Vr Cable. I Tried To Create A Slim But Robust Clip, That Can Be Printed Without Support Material. It Mainly Holds The Connector Unit With A Strong Base Section Designed Around The Cable Outlet. It Also Grabs The Unit With A Little Latch On Its Top Edge To Hold It In Place While Handling It. The Clip Can Be Installed Quite Easy By Inserting The Cable Into The Base Section Gap And Then Slide-In The Connector-Unit Until It Ends Up Locked In Place, Under The Small Latch. The Small Latch Is Designed To Bend A Little To Apply Some Pressure - It Might Be Necessary To Use A Little Screwdriver To Lift The Notch A Bit In Order To Get It Over The Connector-Units Edge (I Had To, But I Guess This Depends On How Your Printer Is Calibrated).
Statistics
Likes
265
Downloads
0