Anet A8 Spool Arm
Description
Very Simple But Effective Filament Spool Holder For The Aneta8 Designed In Google Sketchup. I Suggest Printing A Spool Cap For Your Spool So The Spool Doesn'T Wobble On The Threaded Bar. Settings I Used To Print This. Pla Temp: 200 Degrees Thickness (Wall/Top/Bottom): 0.8Mm Layer Height: 0.3Mm Infill: 25% I Also Created A 4Mm Brim But It'S Not Needed I Just Have Poor Masking Tape. Note: The Slot On One Side Is Bigger Than The Other Side The Slightly Longer One Is For The Threaded Bar, The Shorter One Is So It Doesn'T Hit The Screen Circuit Board.
Statistics
Likes
22
Downloads
0