All in One (AIO) micro brushless 65mm props

Description

***Update 3/3/17**** Since Printing The Reinforced Motor Support I Have Not Broken A Single Frame. I Am Also Using The 3Dxtech Carbon Fiber Nylon Filament. So Strong I Actually Bent The Motor Mount On An 1104 But Didn'T Scratch The Frame. I Have Provided Some Dvr Footage. Https://Drive.Google.Com/Open?Id=0B1Nxzazvai11Ckvsrgdqx2Ffsve The Bent Motor Mount (Fixable): Https://Drive.Google.Com/Open?Id=0B1Nxzazvai11Qwlpbnlkwjvmm28 ***Update**** Got Around To Reinforcing The Arms And Motors. I Flew Into A Tree, The Ground, And A Bench Today Not A Single Crack. Some Of The Crashes Were Enough To Disconnect The Ipex Antenna On My Rx And My Battery Packs. So I Am Content With This Design. Time To Move To The Next! To Accommodate Dys 1104 Motors. A Frame Which Supports 65Mm Props Printed Petg With Hopes Of Using Knurl Inserts To Allow Metal Screws To Be Used With The Frame To Secure Electronics. Electronics Used: 1103 Motors 8.5Mm Motor Mount Spacing - As Speced By Racerstar 1103 6 Amp Esc- Individuals (Pro Tip Don'T Cut Esc Wires) Frysky 2A Rx 2S Lipo, Really Just Two 1S Lipos In Series About 20C And 600Mah (About 5 Minutes Flight) Tx03 Aio Camera, Housing Printed Into The Frame Will Hold The Tx03 Without Modification, Need Mounting Tape To Reduce Jello F3 Femto Board Using Ppm Used Knurled Inserts Size M3 And M3 Threaded Standoffs. To Save Weight You Can Just Use A Longer Bolt. I Am Thinking Of Creating A Stronger Interface Between The Plastic Below The Motor Mount And The Arm. I Found In Hard Crashes The Arm Does Not Fail, But The Motor Mount Exactly Where It Transitions To The Thinner Portion Of The Arm (Directly Under The Motor) Please Do Not Sell This Design.

Statistics

Category

Tags