RAMPS/Arduino Mega Enclosure REDUX
Description
This Enclosure Is A Remix Of Hrishib'S Case (Http://Www.Thingiverse.Com/Thing:2047835). I Liked The General Design But I Wanted To Save The Printers Having To Super-Glue Their Hex Nuts To The Case. This Design Required: 4 X M3 Hex Nut 4 X M3X12Mm Screws ( To Connect The Lid To The Case ) You Will Also Need 4 More Screws And Hex Nuts To Attach The Fan And The Fan Cover. Lengths For Those Are 20Mm **Note** Be Sure To Adjust The Parts In Your Slicer So They Lay Flat On The Bed ** Note ** The Pins To Attach The Arduino Mega Are Quite Tight. You Will Have To Angle The Board And Align The Screw Holes First Then Carefully Press Down Into Place. **Edit 1/22/2017 ** I Have Modified The Pins That Hold The Arduino To Make It Easier To Install In And Remove It **Edit 1/24/2017** I Have Modified The Top Cover To Have A Larger Hole For Fan Ventilation. With The Older Design I Noted That The Hole Was Too Small For Some Version Of The 40Mm Fan.
Statistics
Likes
103
Downloads
0