Polyurethane Pulley
Description
This Pulley Is Designed To Work On A 1/2 Hex Shaft And Run A 1/4 Diameter Polyurethane Timing Belt. I Designed This Pulley For Frc 2017 Steamworks To Pick Up 5" Wiffle Balls On Our Robot. It Is Intended So That The 1/4 Belt Stays In Contact With The Ball Even When The Ball Goes Over The Pulley. The Hex Hole Is .515 Inches So That A Hex Shaft Fits Snug But Without Needing Lot Of Force To Slide Into A Desired Position. The Text Was Added In Team Spirit But Please Feel Free To Remove It If You Decide To Use It On Your Robot Or Other Creation.
Statistics
Likes
2
Downloads
0