Anet A8 Horizontal Filament Holder
Description
Needed A Compact Way To Hold Filament Being Fed To The Printer, Didn'T Like Solutions Already Out There As They Raised The Height Of The Printer Too Much Adding To Wobble And Vibration. While This Solution Still Adds Wobble, It Doesn'T Appear To Be As Much As Solutions Out There At The Moment And With Braces And Reinforcement, Doesn'T Seem To Be An Issue. This Is To Go On The Right Side Of The Printer, Though If Mirrored Before Printing Can Also Go On The Left. This Is Made For The Anet A8 And Was Made To Be Simple But Robust. I Used The Rod And Nuts Included With The Printer For The Spool Holder. Included Are Also 2 Fittings For Allowing Filament Roles To Spin Freely On The Bar With Less Friction. The Hole For The Bar Runs Clean Through In Case You Wish To Raise It Higher For Holding More Than One Role, Lock In Place Using Bolts As Seen In The Pictures. It Is Also Recommended To Use A Filament Guide On The Opposite Side Of The Printer, This Helps Prevent Filament Accidentally Unwinding From The Role.
Statistics
Likes
96
Downloads
0