Maker Ultimate Filament Guide
Description
This Is A Super Simple Part For My Maker Ultimate, But It Serves A Valuable Purpose. Without Some Kind Of Guide, The Filament Occasionally Slips Around The Outside Of The Spool And Stops *Un-Spooling* As The Print Progresses (Especially On A Brand New/Full Role). While There Are More Sophisticated Solutions That Add Bowden Tubes And Lots Of Guide Clips And What Not, This One Is Good Enough To Get Me Printing Fun Stuff Again Fast. On The Back Of The Cabinet Frame, Just Behind The Y-Axis Motor, Is A Little Slot About 6Mm X 18Mm. Simply Push The Mount Through This Slot From The Inside And Then Slide The Guide Into The Notch On The Outside. (See Photo)
Statistics
Likes
11
Downloads
0