Mini SNES Raspberry Pi Zero Case w/ USB controller ports
Description
Remixed From Andrewbougie'S Mini Snes For Pi 2/3. I Opted To Go With The Pi Zero Since They Are Only $5 At Microcenter And Also To Close Off The Openings On The Sides For The Usb Ports And Sd Card. I Also Got Rid Of The Mock Controller Ports And Added Openings For Usb Ports For More Authenticity. Future Improvements I Need To Make Are To The Rear Ports For The Power And Hdmi. Bill Of Materials: -Case: Top And Bottom -Eject Button -2X Power/Reset Buttons -Raspberry Pi Zero -Micro Sd Card -Mini Hdmi To Hdmi Adapter, (Remove The Outer Plastic Shell With A Hobby Knife) -Micro Usb Power Supply -Usb Hubman - Take Off The Plastic Bezels, Cut Off The Male End And Solder The 4 Wires To The Pi Zero Shown Here: Https://Www.Msldigital.Com/Pages/Support-For-Hub-Zero -Controllers Of Your Choice -4X 25 Mm Or Longer M2 Screws, I Couldn'T Find Anything Longer Than 25 Mm Locally -Standoff Stl Files Are Optional, Glue Them To The Top Part Of The Case If You Can'T Find Screws Longer Than 25 Mm Surface Finishing: Sandpaper Filler Putty/Primer For Smoother Finish Light Grey, Dark Grey, And Purple Paint (Acrylic Or Spray Paint) I Also Used A Hot Glue Gun To Keep The Ports In Place And Glued The Board Of The Hub Below The Pi Zero And Covered It In A Layer Of Glue To Prevent A Short Circuit.
Statistics
Likes
90
Downloads
0