Omega Onion Case for Expansion Dock
Description
I Recently Received My Onion 2+ From The Kickstarter And Came Looking Looking For A Case To Put It In. I Found The Onionomega Enclosure By Duan-Za And Printed It Up. I Couldn'T Get The Case To Close Properly Because It Seems The New Onion, When Installed, Is Slightly Higher From The One This Case Was Made For. I Made A Few Changes To The Top Of The Case. I Shortened The Protected Wall Around The Expansion Connector By 1Mm As It Was Also Contributing To The Case Not Sitting Right. I Removed The Lettering From The Top And Added Two Holes For The Leds And A Cutout Over The Mac Address Sticker. I Also Made The Top 1.5Mm Taller. The New Top Fits A Lot Better. The Usb-A Connector Has Moved A Bit And The Separator Between The Two Usb Ports Overlaps The A Connector. It Hasn'T Prevented Me From Plugging Anything Into The Slot, So I Didn'T Change It. If It Does Interfere, It Can Be Easily Removed. I Am Including The Original Bottom From The Remix For Completeness. There Were No Changes Made To It.
Statistics
Likes
21
Downloads
0