Sunhokey firmware configuration.h for MKS gen 1.4 UPDATED
Description
Be Ready To Power Down The Printer If The Firmware Doesn'T Work Please Read The Warning Section In Its Entirety Before Use. This Is The Configuration.H File For Repetier Firmware. Someone Asked About It So Here It Is. Go To Repetier.Com/Firmware/V092/ And Upload The Included File. Change Settings As Necessary And Download The Complete Firmware. Open The Project File Under Arduino Ide Make Sure You Select The Atmega 2560 And The Right Port. Upload And Make Sure The Board Is Wired Correctly. Primary Picture Is Of The 1.2 I Think, But The Boards Are Pretty Much The Same. The Picture Is Correct As Far As Wiring Goes, The Second Z Motor Goes Into E1 The Hot Bed Heater Goes On The Top Left Screw Mounts And E0 Goes Into The Third Position. You May Have To Change The Thermosistors Used According To What You'Ve Got. Baud Rate Is Set To 115200. Updated 6-22-17 Set Eeprom Value To 99, Will Overwrite Eeprom Values Added Warning Section Elaborated On Use Corrected Information
Statistics
Likes
31
Downloads
0