LG840g-Cellphone-IpodShuffleCase
Description
For Lg840G Cell Phones See Also My Version Without The Ipod-Shuffle Case. Just A Cover. Http://Www.Thingiverse.Com/Thing:658862 Wanted To Make Use Of My New Ipod Shuffle And Have With Me When I Wanted It. Use It Sometimes Plugged Into My Car Stereo. It Prints Fine. One Thing To Think Of Before Printing Is, To Print Separately. Do So Because The Phone-Clip Part That Pushes Down Over The Ipod Case Part Needs To Print Slower, About 20 To 30Mm/S, While The Case Pictured Was Printed At 80Mm/S. The Phone-Clip Has The Thin Small Finger Clips Which Need To Print Slowly. Works Out Nice Because The Phone-Clip Part Will Wear Out With A Finger Clip Breaking After A Few Months Of Pocket Use. They Print Quickly. Don'T Forget To Use Support For The Phone-Clip. Hate It, But The Only Way I Could Think To Get All Parts In And Printable. You May Have Some Areas That May Need Gluing Some Velvet Or Paper In To Give A Bit Of More Holding On The Ipod Case Part. For A More Of A Snap In Effect. Hope You Enjoy, Rick. Note: The Picture Shows A Small Piece Of Thin Card Stock Glued Inside The Top Finger On The Phone-Clip Part. The Updated Version 4 With The Download Should Fix This Without Any Card Stock Needed. Update: Also Wanted To Add That The Fingers May Print A Bit Loose And Not Have The Snap-In On The Phone You May Want. The Thing I Did With Mine Is; Use A Micro Torch Or Maybe A Hair Drier To Warm The Top Single Finger And Squeeze It In A Bit. Should Work Fine And Have The Snap-In You Like.
Statistics
Likes
4
Downloads
0