MyGeiger 2 Case
Description
A Simple Case For The Mygeiger Geiger Counter From Www.Rhelectronics.Com. The Photos Show My Version Before I Did Some Changes To The Design, The New Design Should Look Nicer And The Power Switch Hole Was A Little Misaligned. You'Ll Need To Trim The Header For The Display Down About A Mm And You'Ll Need 2 15Mm Male-Female Spacers (Use Nylon As They Are Close To The Hv Section On The Board) The Hole In The Middle Of The Top Radiation Symbol Is For A Led Bezel To Extend The Count Led To The Front Panel (Bezel Is Installed In The Photos But No Led In The Bezel) The 3 Extra Holes In The Bottom Of The Lid Are For A Handle That I Havent Designed Or Decided If I Want Yet..
Statistics
Likes
5
Downloads
0