K8200 E3D Titan Extruder Mount and Fan
Description
A Mount And For The E3D Titan Extruder Fitted With A V6 Hot End And Fan Mount For Three Point Cooling. The Mount Is Derived From Http://Www.Thingiverse.Com/Thing:1710719 By O_Liviu But Elongated To Fully Hold The Motor And With A Push Fit For The Fan Duct. The Fan Duct Is Inspired By The Research Done By Http://Www.Desiquintans.Com/Coolingtests2 Which Indicates That A Combination Of Point And Area Cooling Provides The Best Solution. I Have Therefor Created A Duct That Has Three Air Routes, Half Of The Output Is Directed At The Hot End Tip And Then A Quarter To Each Of The Arms. The Arms Are Separate With A Push Fit Into The Body, For A Number Of Reasons. They Can Be Replaced Independently, I Am Free To Modify The Arm Design, And They Are Easier To Print. Don'T Try And Print This With Anything Wider Than A 0.4Mm Nozzle As The Duct Walls Are Super Thin To Get The Most From The Single Fan. See Http://Www.Thingiverse.Com/Thing:2079048 For The Compete Rebuild Also See A Dual Fan Version Http://Www.Thingiverse.Com/Thing:2170127
Statistics
Likes
3
Downloads
0