MP Select Mini 8mm Gantry Support and Logitech C525 Mount
Description
This Is A Multi-Project Remix/Mashup For The Mp Select Mini. Foremost, It Is A Remix Of [Svideo](Http://Www.Thingiverse.Com/Svideo/)'S [X Gantry Support + Camera Mount](Http://Www.Thingiverse.Com/Thing:1864625) Which Adds Support For An 8Mm Rod And Bearings. If That'S What You'Re After, You Can Just Grab "Base" And "Bracket" And Be Good To Go! Note That I While I Simply Enlarged The Rod Opening On The Base, I Did Entirely Rebuild The Bracket To Add The Following Niceties: - Larger Zip-Tie Holes To Accomodate 5Mm Zip-Ties (Stronger Grip) - Rounded Over Zip-Tie Holes - Accommodation For Slightly Larger Screw Heads Secondly, It Is A Further Remix Of Svideo'S Camera Boom Arm (Itself A Remix Of [3Dkarma](Http://Www.Thingiverse.Com/3Dkarma/)'S [Raspberry Pi Camera Mount With Ball Joint](Http://Www.Thingiverse.Com/Thing:247590)) That Makes The Following Changes To Add Length And Rigidity: - The Boom Base Has Two Zip-Tie Holes That Align With The Middle Holes In The Bracket To Give It Much Greater Attachment Rigidity - The Boom Arm Has Been Lengthened To A Total Of 110Mm - A Rigidity Panel Has Been Added To The Boom Arm - The Boom Base And Boom Ball Socket Now Take Four Arms Instead Of Two Finally, It Updates [Lord_Vader](Http://Www.Thingiverse.Com/Lord_Vader/)'S [C525 Cam Holder For Printers](Http://Www.Thingiverse.Com/Thing:844450) Making It Compatible With The Aforementioned Camera Mount. Note: If The Ball Joint Prints Too Small, You Can Scale It Up By 1-2% In Your Slicer And Print Again. ###Parts - [8Mm Linear Motion Rod](Https://Www.Amazon.Com/Gp/Product/B01M34Zjkf/) - [8Mm Linear Motion Bearings](Https://Www.Amazon.Com/Gp/Product/B01N1Uxinp/) - 2 X M3 15Mm Screws (For Rod Holder Base) - 2 X M3 Hex Nuts (For Rod Holder Base) - 2 X M3 30Mm Screws (For The Camera Boom) - 2 X M3 Wingnuts (For The Camera Boom) - 4 X 5Mm Zip Ties I Use The Camera Mount To Live-Stream Printing At Https://Www.Twitch.Tv/Sihren
Statistics
Likes
61
Downloads
0