HC-05 / HC-06 Programming Holder
Description
Every Time I Wanted To Flash The Firmware On An Hc-05 / Hc-06 I Ended Up Soldering Temporary Wires To The Spi Pads And Once I'D Finished Programming, Removing Them. Thankfully Now I Don'T Have To! This Holder Gives You Access To The 4 Spi Pins Along The Bottom Plus The Vcc And Gnd On The Left Hand Side. **Wires Used** I Used Some Standard Single Core Breadboard / Jumper Wire. I Believe Its 22Awg. Stranded Wire Is Not Worth Trying. ** Holding The Chip In Place** I'Ve Used Both Elastic Bands And Blu Tack With Success.
Statistics
Likes
5
Downloads
0