Unsupported Angle / Overhang Tester, 5 - 90 degrees
Description
This Is A Test Piece I Made To Determine The Amount Of Overhang I Can Use In Designs Without Having To Rely On Supports. I Was Pretty Impressed To See That I Can Get Away With About 70 Degrees Of Angle Or Archway! The Part Prints Out In 5 To 90 Degree Slants In 5-Degree Increments. Level One Is 5-45Deg And Should Be No Problem For Any Printer. Level 2 Is 50-90Deg... You Will Want To Be Present To Abort The Print When It Starts To Spray Filament Everywhere In The 90-Degree Stage :) See A Sample Video Of This Piece Printing At Http://Www.Youtube.Com/Watch?V=Bxs56Qr27Cs
Statistics
Likes
439
Downloads
0