MakerBot Mini Bed Plate Replacement
Description
I Combined Stevefury'S Two Bed Pieces Into One Then Added The Rest Of The Bed For A Total Replacement. You Will Need To Sand The Tabs That Slide In To Get A Nice Fit. There Is A Hole In The Bed For The Short 6Mm Metal Rod, But You'Ll Have To Drill It Out Carefully To Set The Piece In At A Similar Height, Otherwise You Might Need To Adjust Your Z Offset. In Case You Want To Find/Make A New Little Metal Rod, Mine Measured 6Mm In Length Also. I Didn'T Bother Sanding The Top Layer Smooth Before Putting Tape On And Testing It, But You Might Would Want To Before Putting This Into Heavy Use. If You Own A Makerbot Mini, It Might Be A Good Idea To Have A Friend/School/Library/Maker Space Print You An Extra Bed Just In Case You Drop The Original On A Hard Floor And Break It.
Statistics
Likes
13
Downloads
0