Dice Over-sized (200mm)

Description

Hi Thingiversers! This (Obviously) Is A Very Large Dice Which I Modeled Just Big Enough To Fit The Bed On My Printer, But It Was Going To Take Over 15 Hours Just To Print The Body Of The Dice So I Haven'T Done It Yet. The "Hollow" Dice Is In Two Parts So You Don'T Have To Worry About Support On The Inside. The Scallop/S On The Bottom May Need Support. I'M Very Keen To See Any Prints Of Either One Of These That You May Create, Also Would Like Any Comments Or Suggestions Too. Note: The Lid Has A 0.3Mm Tolerance All The Way Around. It Is 200Mm Square. Cheers.

Statistics

Category

Tags