Anet A8 Adjustable Glass Holder
Description
I Designed A Simple Glass Holder For My Anet A8. I Am Using 4Mm Glass Sheet (Should Still Work With 3Mm) And These Work Great So Far. This Is My First Design Project So Any Feedback Is Appreciated. I Recommend Using Slightly Bed Level Screws Or You'Ll Be Compressing Your Springs A Lot. ***** Your Glass Must Be At-Least 7 In By 7 In For This To Work ***** ***** Use Any Size M3 Screws To Adjust Tension On Glass - You Will Need 8 Screws Total ***** Recommend To Be Printed In Abs. If You Only Print Pla And Not Abs Then Pla Might Be Okay. Printed Without Any Supports.
Statistics
Likes
288
Downloads
0