X-Carve X carriage Hard Limit Switch Holder
Description
I Made This To Hold A Second Micro-Switch On The X Carriage Of The Xcarve So I Get The Normal Homing + Hard Limit Because I Use Grbl And You Can Connect Both In Parallel I Male Use Of The 2 Unused M4 Holes That Are Aligned With The Homing Micro-Switch Need : 2 M4 12Mm To 14Mm 1 Microswitch 1 M3 Tap To Enlarge The Microswitch Holes 2 M3 8Mm To 10Mm (My Micro Switch Holes Are 2.4Mm So I Can Use The Tap On It , Dont Do It If You Have Different Micro Switch ; Also If You Do It , Verify That You Didnt Create Shortcut With The Screw )
Statistics
Likes
5
Downloads
0