Anet A8 e3d v6 Bowden Print Carriage cooling duct remix (Remix)

Description

Remix Of This Cooling Duct Http://Www.Thingiverse.Com/Thing:2086437 Directs The Air Straight To The Extruded Material Improving Over Hang Performance Plus A Little Branded Cable Tidy For Mounting On This Carrage Http://Www.Thingiverse.Com/Thing:2077676/#Remixes Update: Also Uploaded My Sensor Mount For Those Who Are Interested, It Only Has One Point Of Contact With The Reset Of The X Carriage So Use The Hex Inlay To Tighten It On Firmly Once You Have It Nice And Level And It Should Be Fine. Mine Has Been Printing For A Week Or So Now With No Movement. You Will Also Need To Change Some Numbers In Your Skynet Config File So Find And Set The Following Values. //Probe Offsets #Define X_Probe_Offset_From_Extruder 33 // X Offset: -Left +Right [Of The Nozzle] #Define Y_Probe_Offset_From_Extruder 0 // Y Offset: -Front +Behind [The Nozzle] #Define Z_Probe_Offset_From_Extruder 0 // Z Offset: -Below +Above [The Nozzle] // Travel Limits After Homing (Units Are In Mm) #Define X_Max_Pos 220 #Define X_Min_Pos -10 #Define Y_Max_Pos 220 #Define Y_Min_Pos -14 #Define Z_Max_Pos 240 #Define Z_Min_Pos 0 // Set The Boundaries For Probing (Where The Probe Can Reach). #Define Left_Probe_Bed_Position 28 #Define Right_Probe_Bed_Position 192 #Define Back_Probe_Bed_Position 192 #Define Front_Probe_Bed_Position 28

Statistics

Category

Tags