40mm Fan w/ Pivot Arm
Description
It Has Been A While Since I Uploaded Something To This Website But I Figured I Should Start Sharing My Creations In Hopes They Might Benefit Others Down The Road. This Is A Built-From-Scratch 40Mm Fan With Pivot Arm That Runs On A Small Hobby Motor. The Dc Motor Is A 6V One That I Salvaged From An Old Inject Printer, So Sadly I Have No Further Information On It. The Fan Shroud Has Two Clip On Points So A Second Fan Shroud Could Be Attached To Redirect The Air Flow. 3 Small Screws Attach The Fan Shroud To The Motor Mount. The Pivot Arm Uses A M4 Bolt And Nut And Is Approximately 65 Mm Long. The Fan Blades Pressure Fit To The Motor Coupling. If It'S A Little Lose You Can Wrap The Coupling In Teflon Tape To Make It A Tighter Fit. Made In Fusion360: Http://A360.Co/2Leuxwa This Was Originally Designed To Cool The Dc Motor To A Water Pump I Built, That Is What The Background Of The Pictures Are. Works Well And Is A Little More Nosier Than A 40Mm Pc Fan.
Statistics
Likes
9
Downloads
0