Hydraulic Helper: 10x175mm Hydraulic Arm Gate/Door Support Rod
Description
The Hydraulic Arms On The Rear Gate/Door Of My 2002 Dodge Durango Wouldn'T Support The Weight Of The Gate/Door When The Outside Temperature Was Below About 55F. Since I Only Use The Rear Door A Few Times Each Year When The Temperature Is That Low (Since I Live In Texas), I Didn'T Feel It Was Worth Replacing The Hydraulic Arms On Both Sides And Decided To Come Up With A Quick Design To Print To Take Care Of The Problem. Designed In Fusion 360 And Printed On A Monoprice Iiip/Wanhao I3 Plus. The Hydraulic Arm Is Approximately 10Mmod X 175Mm Shaft Length, So The Support Arm I Created Has An Id Of 10Mm And A Length Of 175Mm. It Clicks Into Place And Requires A Bit Of Force To Remove From The Hydraulic Arm - Working As I Had Inteneded When Designed.
Statistics
Likes
5
Downloads
0