Trinus Filament Guide Ball Bearing
Description
Please Read The Following Notes. Inputa&B (Enclosure Guide): This Is A 2Pc Snap In Unit. This Encapsulates 5 Magnetic 3Mm Ball Bearings. Place Both On The Same Build To Help Cool Down During Build. For Best Result Use 0.15Mm Layer And Slower Speed, This Has A Single Wall Snap In Feature. Bottom Section & Top Cover (Extruder Guide): This Is A 2 Pcs Snap In Design. This Again Uses 5 Magnetic 3Mm Ball Bearings. I Suggest Using Support To Build Both, But Make Sure On The Bottom Section Part, You Remove The Support Inside The Key Hole For The Top Cover. If Not You Wont Be Able To Insert The Top Cover. I Also Included A Small 10X1Mm Indent On The Longer Leg, This Was Designed So You Can Install A Round Cabinet Bumper Or Pad. Adding One Will Increase The Grip On The Extruder And Help Prevent Movement During X-Axis Shifts. Note: This Was Designed So That Only The Magnetic Ball Bearings Are The Only Thing Touching The Filament. This Reduces The Friction And Helps Create A Smoother Feed. 3Mm Magnetic Ball Are Actually Buckyballs, You Can Find Them Online. Another Good Thing Is To Build A 608 Ball Bearing Spool Feeder, This Will Help Reduce The Friction And Aid In A Smoother Filament Feed. Design By Los
Statistics
Likes
30
Downloads
0