Diatone GrassHopper Quadcopter Frame Canopy
Description
I Didn'T Really Liked The Diatone Grasshopper Frame. None Of The Cameras I Had Fitted Properly, 4 Inch Props Was Impossible. I Decided To Pimp The Grasshopper Up And Designed My Own Canopy For It. This Design Also Incorporate A New Type Of Tx Antennas Holder Made To Hold And Remember Their Positions. It Worked Out Pretty Well! This "Thing" Is The Outcome. Printed Using Cheetah Filament. Hardware Needed: * 2X 35Mm Round Alu Spacers * 4X 10Mm M3 Screws * 4X 8Mm M3 Screws * 2X M3 Nuts * Common Nylon Standoff, Screws And Nuts.. The Camera Holder Is Made For These Types Of Cams: Http://Www.Banggood.Com/Realacc-Gx210-13-Cmos-700Tvl-Fpv-Camera-2_6Mm-110-Degree-Lens-Pal-Ntsc-Switchable-24X17Mm-P-1096914.Html?Rmmds=Category (Sorry I Cant Find The Link To The One I Used, Its Probably Obsolete..) Tx = Xsr Vtx = Cheap Eachine 200Mw Fc = Picoblx (Genuine) Leds = Whatever You Like. Battery = Tattu 3S 650Mah 75C With Xt30 Connector Pdb = None (Picoblx Take'S Care Of It) Osd = None (Still Has Room For A Mmosd If Needed) Props = 3 Or 4 Inches Motors = Rcx 1306 Esc = Lb 20 Amps
Statistics
Likes
71
Downloads
0