Black Widow Bites MK1
Description
This Is A Set Of Black Widow Bites I Made For A Friends Cosplay, I Used Modifications Of Http://Www.Thingiverse.Com/Thing:456900 Aaa Battery Holder To Power It And Http://Www.Thingiverse.Com/Thing:505184 To Make Each Piece Connect Together And Articulate. This Design Only Requires 3 Aaa Batteries To Power The 3Mm Blue Led'S I Used A Single 100Ohm Resistor And Wired Them In Parallel. There Is A Small Square Hole For A 9Mm X 4Mm Switch. For The Wires I Just Used Some Old Cat5 Cables. If You Decide To Do This Make Sure You Used Patch Cables That Are Stranded And Not Solid Wire. I Recommend Not Using A Brim On The Battery Holders Because Cleanup Can Be A Bit Of A Pain And Cause Binding.
Statistics
Likes
58
Downloads
0