Dial Indicator Mount - Duplicator i3
Description
The Original Was Nearly Perfect, Except That The Indicator Hole Was Too Small, And The Gap To Tighten It Down Was Non-Existent When I Printed. I Increased The Gap To 1Mm, And Made Two Versions For Different Hole Sizes. The 10Mm Was Just A Tad Too Large For My Gauge, So I Made A 9.5Mm Version As Well. As You Can See, This Still Didn'T Work For My Gauge. It'S Leg Was Too Short To Touch The Build Plate. I Made A Low Rider Version That Does Work Though. The Link For It Is Down Below. I Also Added The Fusion 360 Source Files For Those That Want To Customize It More. Don'T Use This As Your Primary Source Of Leveling. I'D Recommend Using The Feeler Gauge/Paper Method To Get It Pretty Closed, Then Use This To Fine Tune It. Trust Me, It'Ll Save You A Ton Of Time. It Uses An M3X15-20Mm Bolt And M3 Nut. I Only Had 20Mm Bolts, But 15Mm Should Be Plenty. Also, This Mount Is For Dials That Do Not Have The Back Plate With Mounting Holes (For Traditional Use). If Yours Has The Mounting Holes On The Back, There Are Plenty Of Other Great Mounts Already Made On Thingiverse. Low Rider Dial Indicator Mount: Http://Www.Thingiverse.Com/Thing:2153312 Cheers!
Statistics
Likes
8
Downloads
0