Left handed duplicator 6 blower cooling duct
Description
So Another Cooling Duct Modification/Upgrade For The Wanhao Duplicator 6. It Really Needs More Air Then Stock But There Is Not A Lot Of Room To Add A Blower On The Right Side If You Have A Enclosure. And Radial Fans Just Are So Weak. So, I Put A 40X40X20Mm Blower On The Left Side :) Gdstime 4Cm 40Mm 24V Dc Brushless Blower Cooling Fan One Issue Is I Made A Clip (Middle Top Tab) That Only Works On The Swiss Hot End Upgrade Heat Sink (It Has Different Spacing Then The Stock Heat Sink Fins) I Might Take That Out Entirely As It Was To Ensure No Sag But The Petg I Printed It With Is Working Fine. (Also Have A Boot Which Imo Is A Must! For Best Printing) The Heater Core Wires Get Hot And Can Deform Any Cooler That Is Close In, But Again This Is Working Just Fine. This Is A First Draft And I Have One Prototype Running On My System Currently. Feel Free To Comment, Offer Suggestions, Or Make A Remix.
Statistics
Likes
37
Downloads
0